Automatic Numbering in Drill-Down diagrams

General Questions/Discussions
#1

Hello Jick

Is there a possibility to have an automatic numbering at each diagram when you drill-down so you know exactly where you are when Process-Diagrams are getting very complex?

For Example:

  • Main diagram: 1

  • 1st drill down diagr.: 1.1, 1.2, 1.3…

  • 2nd drill down diag.: 1.1.1, 1.1.2, 1.1.3, 1.2.1, 1.3.4…

Grts,

Joeri

#2

Hello Joeri,

This is a good suggestion. We hope to support it in VP Suite 3.1 Service Pack 2. Will let you know once there are any news.

Best Regards,
Jick

#3

Hello Jick,

Thx again for your fast reply.

Will it also be visualised in BPVA and in the HTML-generated?

Have a nice day,

Joeri

#4

Sure. The ID will show in both the tool and the reports, like now.

#5

Has this functionality been rolled out yet? If so how do I use it?

Thanks

#6

Hi Dan Potter,

Thanks for your post. We are sorry that currently this is not supported, but I’ve fired a request to our engineers to follow-up. If I get any news about this issue, I’ll notify you immediately.

By the mean time, if you have any inquiry, please do not hesitate to contact me.

Best regards,
Lilian Wong